Utility Brain

Read your gas meter's dials or pulses

Every gas meter shows its total on an index, either a row of digits or a set of clock dials. Most also have a small test dial that turns once per fixed volume, commonly ½, 1 or 2 cubic feet per revolution, printed beside it. Watching that dial gives you live gas flow, whatever radio the utility uses.

Three ways to watch it

  • A camera on the index. An ESP32-CAM or similar pointed at the digits, with digit-reading firmware such as the open-source AI-on-the-edge-device project, logs the total every few minutes.
  • A magnetic sensor. On many diaphragm meters a magnet in the index's last digit wheel turns past the cover. A magnetometer or reed switch held against the outside counts the turns.
  • A reflective sensor. Some indexes have a mirrored or white segment on the lowest digit. An infrared reflective sensor counts it the same way.

From counts to flow

cubic feet per hour = 3600 × (volume per count) / (seconds between counts)

Your bill converts cubic feet to therms with the heating-value factor printed on it, often about 1.03 therms per 100 cubic feet.

Stay on the outside

Mount sensors with tape or a clip on the outside of the index cover. Don't open the index, break seals or loosen fittings: the meter belongs to the utility, and gas fittings are a safety matter.

Get live readings from your own meter

We are building Utility Brain, a small receiver that reads your electric meter the way your utility does and shows your usage minute by minute. Join the list and we'll tell you when it works with your meter.

We only use this to tell you about Utility Brain. Privacy.